Timken works on incrementally increasing fuel economy through bearings
In this day and age, you might think that we have reached the pinnacle of the internal combustion engine. Having been using the design, you might assume that designers and engineers have gotten all of the efficiency out of the design that they can. However, recent advances like HCCI, variable valve timing and even adding heat recovery systems have proven that there is still life left in our good friend, the four-stroke engine. Yet, is the only hope of efficiency gains with major changes to the design of the engine? Maybe not. Timken is a major supplier of the bearings in our engines and other parts of our cars. They are using technology that is usually used for electric devices like speed controllers and sensors, known as the Hall effect, to monitor the load on their bearings and possible find efficiency gains. By incorporating this technology into their current offerings, they have created a "shaft-torque sensor" which will allow them to monitor how much torque is acting on internal components, which could allow them to optimize the component, reducing friction. They also say that there is potential to maximize the potential fuel economy by installing the sensors in a transmission.
Until a real game-changing technology takes over our cars drivetrain, we should look for as many incremental improvements as we can get.
[Source: Wards Auto World]
Reader Comments (Page 1 of 1)
rgseidl 11:17AM (8/19/2007)
Once a bearing is installed, there's not much you can do to reduce its internal friction. Instead, you want to select the right bearing to begin with when designing the engine or transmission. Angled double roller bearings are generally considered to have lower internal friction than the type shown above. This applies especially to the transfer cases of RWD and AWD vehicles, which feature active conical gears. (Note that most differentials also use conical gears but these are only active during cornering)
Another way to substantially reduce friction losses in the drivetrain is to replace the conventional hydrodynamic bearings with roller types. This has significant consequences for assembly, noise and longevity. However, FEV - a Tier 1 engineering consultancy in Germany - claims to have solved these problems. Critically, their concept relies on connrods that are NOT split and counterweights that are bolted to the crankshaft only after the connrods and all bearings have been mounted:
http://www.all4engineers.com/index.php;site=a4e/lng=en/id=6314/alloc=3
Reply